广旭国际贸易(珠海)有限公司客服热线:18088893953
浆液循环泵出口压力低的可能原因及处理方法

浆液循环泵出口压力低的可能原因及处理方法

作者:广旭国际贸易    来源:    发布时间:2020-08-03 10:04    浏览量:
浆液循环泵出口压力低的可能原因及处理方法
浆液循环泵出口压力低的可能原因及处理方法(图1)
    浆液循环泵出口压力低的原有和处理办法:
 
    1.循环泵入口滤网有异物堵塞导致入口压力低流量下降,切循环泵进行冲洗入口堵塞。
 
    2.循环泵入口处浆液沉淀导致入口流量低,查看吸收塔搅拌器运行情况及调整浆液密度ph值,切循环泵进行冲洗入口。
 
    3.吸收塔液位低,提高液位,。
 
    4.吸收塔密度降低,导致压力降低,正常现象。
 
    5.循环泵入口进入氧化空气,停用附近氧化分支管,观察效果,确认后停机改造。
 
    6.循环泵入口泄漏造成入口压力降低,对应补漏。
 
    7.循环泵入口阀门开不到位造成入口流量变小,调整入口门行程。
 
    8.压力表失准,体测压力计表
 
Possible causes and treatment of low outlet pressure of slurry circulating pump
 
 
The original and treatment method of low outlet pressure of slurry circulating pump:
 
1. The inlet filter screen of the circulating pump is blocked by foreign matters, which leads to low inlet pressure and low flow. Cut the circulating pump for flushing and the inlet is blocked.
 
2. Low inlet flow is caused by slurry precipitation at the inlet of the circulating pump. Check the operation of the agitator in the absorption tower and adjust the pH value of slurry density, and switch the circulating pump to flush the inlet.
 
3. If the liquid level of absorption tower is low, increase the liquid level,.
 
4. The density of absorption tower decreases, which leads to the decrease of pressure and normal phenomenon.
 
5. The oxidation air enters into the inlet of the circulating pump. Stop the nearby oxidation branch pipe, observe the effect, and stop the machine after confirmation.
 
6. The inlet pressure of the circulating pump decreases due to the leakage at the inlet of the circulating pump, and the leakage shall be repaired accordingly.
 
7. If the inlet valve of circulating pump is not opened in place, the inlet flow will be reduced, and the stroke of inlet valve shall be adjusted.
 
8. The pressure gauge is out of alignment, and the body pressure gauge is measured
友情链接:   

在线客服 :     服务热线:18088893953     电子邮箱: chengdulaien@126.com

公司地址:珠海市前山港昌路598号2100商铺之一

广旭国际贸易(珠海)有限公司 简称广旭(珠海),公司设立在改革开放的前沿经济特区-珠海,在工业领域行业中的一家出名贸易公司。主要经营进口德、美、日等国家各种工业产品。专业渠道直接从国外厂家进口各大品牌全系列的仪器仪表、进口阀门、进口水泵、控制器、电机、开关、等产品,主要代理品牌有德国《LOCKE》洛克、美国《KHK》、美国《LAINE》莱恩、美国江森、英国《SpiraxSarco》斯派莎克、日本《VENN》阀天、日本《KITZ》北泽、丹麦《GRUNDFOS 》格兰富水泵、瑞典《ITT》飞力…

Copyright © 广旭国际贸易(珠海)有限公司 版权所有   
在线客服 联系方式 二维码

服务热线

18088893953

扫一扫,关注我们